Tar River SRB-870 Owner's Manual page 13

Mini Round Baler SRB-870
Attaching wheels:
Remove the wheels from the baling chamber, unlock the flow control valve and close the rear door. Cau-
•
tion: Before closing the rear door make sure no one is standing near the rear of the baler.
Using the tractor 3-point, lift the baler high enough to insert wheels into baler frame.
•
Insert the shaft of one wheel assembly on to the baler frame as shown below.
•
There are two indents on the shaft. Line up the indent with the bolt hole in baler frame. Thread the bolt un-
•
til it locks into the indent on the shaft. Tighten the bolt and lock nut. Repeat for the other wheel assembly.
The wheels can be set in two positions. Choose the position best suited for your application.
•
LH Wheel Assembly
Assembly
RH Wheel Assembly
13