Tar River SRB-870 Owner's Manual page 16

Mini Round Baler SRB-870
Step 3: Once the twine is thru the RH storage compartment wall, feed twine thru the tensioner and front twine
guide. Wrap the twine around the pulley once as shown in the small or large slot depending on application. See
"Bale Density" for selecting proper slot.
Feed twine through the rear guide and through the opening in the RH side of baler wall.
Step 4: Feed the twine thru the lower guide, upper guide and lastly the Binding Arm Tensioner. Leave approx-
imately 12" of twine hanging from the tip of the Binding Arm. Do not allow the twine to come in contact with
the chamber rollers. The twine could be pulled into the chamber and trigger the bale wrapping mechanism or
become tangled in the rollers.
Assembly
Twine Guides
Upper Guide
Lower Guide
16
Twine Tensioner
Binding Arm
Tensioner