Mini Round Baler SRB-870
Pick-up Suspension:
The pick-up suspension is supported by springs on both sides of the baler. Check the spring with the pick-up in
the working position. The correct length of the spring is 1-7/8". Be sure to check both springs. Adjustment to
the springs is made by loosening or tightening the nuts on the rod.
Twine Tension:
Check the tension on the twine tensioner springs prior to baling.
•
There has be sufficient tension on the twine so that it stays on the guides and is cut at the end of the baling
•
operation.
If the tension is too tight it will not properly feed through the guides possibly breaking the twine.
•
The springs are adjusted by tightening or loosening the nuts.
•
Twine Tensioner 1 (under RH side cover)
Adjustments
Pick-up Suspension
Twine Tensioner 2 (end of binding arm)
25