Table of Contents
Advertisement
Specifications
Model
ICASA
Connectors
Antenna Impedence
Frequency
Power output for single cell
phone (Uplink) dBm
Power output for single cell
phone (Downlink) dBm
Power Requirements
Each Signal Booster is individually tested and factory set to ensu
hardware. The Signal Booster will amplify, but not alter incoming and outgoing signals in order to increase coverage of authorized frequency bands only. If the Signal Booster
is not in use for five minutes, it will reduce gain until a signal is detected. If a detected signal is too high in a frequency band, or if the Signal Booster detects an oscillation, the
Signal Booster will automatically turn the power o on that band. For a detected oscillation the Signal Booster will automatically resume normal operation after a minimum of
1 minute. After 5 (five) such automatic restarts, any problematic bands are permanently shut o until the Signal Booster has been manually restarted by momentarily removing
power from the Signal Booster. Noise power, gain, and linearity are maintained by the Signal Booster's microprocessor.
This device complies with
ICASA
rules. Operation is subject to two conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by
authority to operate this equipment.
11
Single Room Cell Signal Booster
880-915 / 925-960 1710-1785 / 1805-1880 1920-1980 / 2110-2170
30
15
ICASA
re
compliance. The Signal Booster cannot be adjusted without factory reprogramming or disabling the
ale
50 Ohms
30
17
5 V / 3 A
30
20
could void the
Advertisement
Table of Contents
