6 Installation
The following instructions assume that you have installed an Ethernet Card including related software and
Vieworks Imaging Solution in your PC. For more information, refer to your Vieworks Imaging Solution
Installation Manual.
To connect the camera to your PC, follow the steps below:
1.
Make sure that the power supply is not connected to the camera and your PC is turned off.
2.
Plug one end of an Ethernet cable into the RJ45 jack on the camera and the other end of the Ethernet cable
into the Ethernet Card in your PC.
3.
Connect the plug of the power adaptor to the power input receptacle on the camera.
4.
Plug the power adaptor into a working electrical outlet.
5.
Verify all the cable connections are secure.
6.1
Mount Plate
The Mount Plate is provided as an optional item.
The camera can be fixed without using this Mount Plate.
16 of 94
VA GigE series
RA14-131-003