Logs Screen Error Messages - Canon 08011-41-UD2-003 Installation And Configuration Manual

Message
Application Display Name
cannot contain the
following characters: 'x',
'y', 'z'
*Warning!: Due to the size
of the Application Display
name entered, Application
Display Name may cover
the Authorized Send tab
icon.
*Warning!: Due to the size
of the Application Display
name entered, Application
Display Name may be cut
off.
* This denotes a warning message. A warning message will not stop the saving of the configuration
data.

6.1.11 Logs Screen Error Messages

This section explains the Logs screen error messages, along with possible causes and
remedies. For more information on the remedies, see
p. 117.
Message
Port for Syslog Server x
must be a number.
Port for Syslog Server x
cannot be zero.
Port for Syslog Server x
must be a positive number.
Unknown host: server
At least one Syslog Server
must be configured.
Authorized Send Installation and Configuration Guide for imageRUNNER Machines
Cause
The [Application Display
Name (up to 20 characters)]
text box contains 'x', 'y', and
'z', which represent invalid
characters.
The application display name
entered in the [Application
Display Name (up to 20
characters)] text box may be
covering up the icon on the
display tab.
The application display name
entered in the [Application
Display Name (up to 20
characters)] text box may get
cut off on the display tab.
Cause
The syslog server x, where x is
1, 2, or 3, has a UDP port whose
value is not a numeric value.
The syslog server x, where x is
1, 2, or 3, has a UDP port whose
value is zero.
The syslog server x, where x is
1, 2, or 3, has a UDP port whose
value is a negative number.
An unknown host, represented
by server, is entered in the
[Syslog Server] text box.
The [Enable Syslog] check box
is selected, but no syslog servers
are configured.
Remedy
Make sure the application display
name is using valid characters.
See step 2 in "Configuring
Optional Settings," on p. 113.
If this result is not desirable,
reduce the size of the application
display name entered.
If this result is not desirable,
reduce the size of the application
display name entered.
"Configuring Log Settings,"
Remedy
Enter a numeric value for the
UDP port.
Enter a numeric value greater
than zero for the UDP port.
Enter a numeric value greater
than zero for the UDP port.
Check the host and try again.
Either configure at least one
syslog server or clear the check
mark from the [Enable Syslog]
check box.
on
161