Error Messages - Canon WebView Livescope User Manual

7. Error Messages

Error messages are displayed only when the viewer is in Normal Mode ( P. 5).
Message
Operation/Status
Condition
Message
Operation/Status
Condition
Message
Operation/Status
Condition
Message
Operation/Status
Condition
Message
Operation/Status
Condition
Message
Operation/Status
Condition
Message
Operation/Status
Condition
No response from the server.
To connect to the server.
Connection to the video server has failed.
No response from the camera control server. You can use video
only.
To connect to the server.
Connection to the video server is established but not to the
camera control server.
Network is busy. Please try again later.
To connect to the server.
The number of clients that can be connected simultaneously
from the viewer has reached the maximum specified at the
camera server.
The connection to the server is restricted.
To connect to the server.
Access restrictions have been set at the server.
The camera is switched off or faulty.
Connected.
The camera is switched off or broken.
Could not get camera control privileges.
To tap the Start Control button.
The number of the clients waiting for control privileges has
reached the maximum specified at the camera control server. Or
another client with camera control privileges higher than
yourself is connected to the server.
100 camera sites already registered. This camera site will not be
auto-registered.
To connect to the server by wvh file or entering the address directly.
The server being connected is not registered and 100 camera
sites are already registered with the viewer.
17