Displaying System Information - adept technology T20 User Manual

7. Press OK. A screen displaying status messages about the update will be displayed. The
messages will indicate that the system was able to detect the firmware update and that
the firmware update was successfully verified.
8. Press OK. The firmware will be copied to the pendant.
9. After the update has completed, the pendant reboots automatically.
If you encounter any problems while updating the firmware, check the following:
Make sure the Micro SD card is fully inserted in the pendant and that you reboot the
l
pendant after inserting the Micro SD card.
Make sure the firmware update files are stored in a folder named "T20Update" on the
l
Micro SD card.
The update package performs a checksum test to verify the contents of the update files.
l
If any of the files are corrupted, the update package will fail to verify the contents. If this
error occurs, obtain new update files from Adept and perform the firmware update
again. See How Can I Get Help? on page 10.
NOTE: In the event a firmware update fails, you can operate the pendant using the
factory-installed firmware, which is always present on the pendant.

4.7 Displaying System Information

The Information screen displays identity information about components of the system, as
returned by the "ID" monitor command. See the eV+ Operating System Reference Guide for details.
Additionally, it displays the IP address of the connected controller.
To access the Information screen:
1. From the Home screen, press Next to display Home screen 2.
2. From the Home 2 screen, press Maint (F3). The System Maintenance screen opens.
3. From the Maintenance screen, press Info (F1). The following screen opens.
Chapter 4: Maintenance
Figure 4-2. Location for Inserting Micro SD Card in Pendant
Adept T20 Pendant User's Guide, Rev. A
Page 42 of 50