Operating Environment; Installation; About Jumper Plugs; Installing The Pendant And An Adept Front Panel - adept technology T20 User Manual

2.6 Operating Environment

The Adept T20 pendant is designed to operate in the following environment:
Temperature: 0° to +45° C (32° to 113° F)
l
Humidity: 0 - 95%, non-condensing
l
The Adept T20 pendant is not intended for use in hazardous environments (explosive gas,
water, dust, oil, or mist). It has an IP rating of IP-65.

2.7 Installation

This section describes how to install the Adept T20 pendant on a SmartController EX. The fol-
lowing installation options are described:

Installing the pendant and an Adept Front panel

l

About Jumper Plugs

There are two jumper, or bypass, plugs available for a T20 pendant system. One is a D-Sub
plug (P/N 10052-000) for the XMCP connector on the Adept SmartController EX. The second is
a screw-to-lock plug (P/N 10048-000) for the pendant adapter cable.
The pendant emergency stop switch and the enabling switch are wired into the system emer-
gency stop circuitry. Therefore, if either the pendant cable or the adapter cable is unplugged,
the corresponding jumper plug must be installed. If neither one is connected, you cannot ena-
ble high power. If the E-Stop circuit is opened by removing one of the cables, or a jumper plug,
then high power is turned OFF.
See the sections that follow for installation instructions.
Installing the Pendant and an Adept Front Panel
Refer to the drawing that follows for information on connecting a Front Panel to a Smart-
Controller EX, in addition to the Adept T20 pendant. See the
for additional information.
Chapter 2: Installation and Setup
Adept T20 Pendant User's Guide, Rev. A
Page 14 of 50
Adept SmartController User's Guide