Maintenance And Care; Declaration Of Conformity - STEINEL RS PRO CONNECT R10 Manual

Grouping
The RS PRO Connect R10/R20/R30 can be operated
as a single light or interconnected with several lights
by wireless communication to form a group.
All lights belonging to a group operate in line with
the group parameters set in the Steinel Connect
app. Reach can be set individually for all lights in
the lighting group.
Fade Time
Fade Time can be used to set the rate of dimming
on switching the light ON and OFF (1 s - 3 s).
Neighbouring-light function
The neighbouring-light function can be activated
and deactivated via the Steinel Connect App. This
function assigns the neighbouring groups to the
active lighting group. The active group responds
to activation signals from the neighbouring group
assigned to it and switches to main light or basic
light as defined in the settings.
Presence detector function
The presence detector function can be activated
and deactivated via the Steinel Connect App. The
presence detector function should be activated
to increase the sensitivity of sensor detection
after switching the light ON. This then enables
the sensor to also, for example, detect slighter
movements such as arm or hand movements once
a person has entered the detection zone (making
pronounced movements). This prevents move-
ments outside the chosen detection zone from
switching light ON when it is not needed but leaves
light switched ON in response to less pronounced
movements. To avoid light being switched ON all
the time, at least one movement must be detected
every ten minutes. If this is not the case, the sensor
leaves sensitive mode and the light switches OFF
after the stay-ON time elapses. Deactivate the pres-
ence detector function if the light is left switched
ON when it is not needed.
Light distribution curve (Fig. 6.2)
7. Accessories
Emergency light module
EAN 4007841064143

8. Maintenance and care

The product requires no maintenance.
The light enclosure can be cleaned with a damp
cloth (without detergents) if dirty.
Important:
The control gear cannot be replaced.
9. Disposal
Electrical and electronic equipment, accessories
and packaging must be recycled in an environmen-
tally compatible manner.
Do not dispose of electrical and electronic
equipment as domestic waste.
EU countries only:
Under the current European Directive on Waste
Electrical and Electronic Equipment and its imple-
mentation in national law, electrical and electronic
equipment no longer suitable for use must be col-
lected separately and recycled in an environmentally
compatible manner.

10. Declaration of Conformity

Hereby, STEINEL Vertrieb GmbH declares that
the radio equipment type RS PRO Connect R10 /
RS PRO Connect R20 / RS PRO Connect R30 is in
compliance with Directive 2014/53/EU. The full text
of the EU declaration of conformity is available at
the following internet address: www.steinel.de
– 18 –