Current SILENT TRAC Installation Manual page 8

7. INSTALL THE FASCIA CLIPS (Only for applications with fascia)
If you are using a fascia, install all the fascia clips into the track
before installing the track onto the camlocks.
Snap the fascia clips into the recess at the top of the track, one side
at a time starting with the front side of the clip. See Figure 18.
Insert fascia clips at each end of the track, then every 16-32 (24-
36") inches in between where the camlocks will rest.
8. INSTALL THE PIN CONNECTORS
Install the pin connectors before installing the track onto the
camlocks. See Figure 19.
Choose one or more connection points on the top of the track end,
then snap the pin connector into the chosen recess or recesses. See
Figure 20.
9. INSTALL THE TRACK
Before installing the track, note the direction of the carrier arms
and what end the motor controller will be mounted.
Begin with the camlock arm in the open position. See Figure 21.
Figure 18 - Snap in fascia clips
Figure 19 - Pin connector placement options
Figure 20 - Snap in pin connector
Figure 21 - Camlock in open position with arm towards wall
8