Current SILENT TRAC Installation Manual page 13

Power up the Pendant by plugging the input of the power cable
provided into the bottom jack of the Pendant. Plug the wall port
into a desired outlet. See Figure 40.
Figure 40 - Connecting Pendant to Wall Outlet
On units with power and control over CAT5e or CAT6, run the
wire as desired to the power and communication port. See Figure
41.
Figure 41 - Connect to Power & Communication port with CAT5
Plug the ethernet cable into the port at the bottom of the sensor box
housing or motor. See Figure 42.
Figure 42 - Plug ethernet cable into bottom of Sensor Box or Motor
Be sure to secure any excess cord, leaving no more than 8 inches unsecured, to reduce the risk of child strangulation.
2. SET DEFAULT OPEN AND CLOSE LIMITS
Now that your track is installed and power has been applied, the
track needs to find it's open and close limits. Pull down and release
the pendant to send the curtain to the full open position. Once the
curtain has reached this limit and had a hardstop, pull down and
release the pendant to send the curtain to the full close position and
let it set that hardstop. See Figure 43.
You can now move on to optional custom programming.
Figure 43 - Set Limits
THIS IS THE END OF CEILING MOUNT INSTALLATION INSTRUCTIONS. PLEASE REFER TO OUR OTHER
INSTRUCTIONS FOR PROGRAMMING, ZIGBEE SET UP, AND FASCIA INSTALLATION. FOR ANY
QUESTIONS OR ASSISTANCE NEEDED IN INSTALLATION OR PROGRAMMING, PLEASE CONTACT US!
844-307-7435
support@currentproductscorp.com
13