Current SILENT TRAC Installation Manual page 11

12. ATTACH THE DRAPERY (Optional)
Snap or hook the drapery into each carrier, starting with the master
carrier arm(s) and ending with the end(s) of the track.
Wrap and pin the remaining fabric around the motor using the pin
connectors, hiding it from plain sight, but making sure the Pendant
is accessible. See Figure 31.
Figure 31 - Hook or snap drapery onto carriers
In some cases, it is desirable to connect the return of the drapery to
the wall with an eye hook. Screw an eye hook into the wall where
the last pin will go, then insert the pin through the eyelet. See Figure
32.
Figure 32- Screw in eyelet then insert pin through the opening
13. ATTACH THE BATON (Optional)
If using a front baton, the plastic reinforcer must be sewn into the
drapery and the grommet punched in advance of the drapery being
installed. See Figure 33.
For a front mounted baton, slide the plastic wedge through
the slat in the carrier arm. Place the plastic baton hook over the
grommet and screw in the screw to secure.
Figure 33 - Baton view
For a back mounted baton, locate the eyelet under the carrier
arms and connect the baton with a clip. See Figure 34.
Figure 34- Hook back baton through eyelet in carrier arm
11