Current SILENT TRAC Installation Manual page 7

Once the camlocks have been installed, twist the camlock to the
open position (arm facing straight back towards the wall/window)
so it is ready to receive the track. See Figure 13.
Figure 13 - Set camlock to the open position
6. ADJUST NUMBER OF CARRIERS AND ORIENT CARRIER ARMS
It may be necessary to add or remove carriers based on the drapery
fullness.
To add or remove carriers, loosen the screw on the hardstop and
slide it out of the track. See Figure 14.
Figure 14 - Remove hardstop
For pleated drapery, count the number of pleats on the drapery
panels. Insert or remove carriers until the correct amount remain
in the track. See Figure 15.
Two pleats are installed on most carrier arms. Two or more pleats
may be used at the end/return of the track. On a center draw, do this
on each side.
Figure 15 - Add or remove pin carriers
For drapery with connected carriers, please exercise caution. To
remove carriers, simply slide the desired number to be removed
from the track and cut the string. To add carriers, the whole string
will need to be replaced. See Figure 16.
In some cases, extra carriers are left in the track for future uses and
to avoid needing to replace string spacers.
Slide the hardstop back into the track and tighten the screw.
Figure 16 - Add or remove string carriers
Based on where the window is located, there may be a desire to
reverse the orientation of an overlap carrier arm set. To reverse the
orientation, unscrew each arm from the master carriers, and swap
the two. See Figure 17.
Figure 17 - Reorient carrier arms
7