Table of Contents
Advertisement
<Remaining-thread allowance
length selection screen>
M
<Data input screen>
<AW operation screen>
4)
Set the number of stitches where necessary. It is necessary to
J
set the number of stitches without exceptions in the case the
"manual" is selected.
* In the case the "manual" is selected, set the counter set value
on the counter setting screen.
* In the case the "auto" is selected, press
setting screen.
Choose the remaining thread margin length from 0 to 3.5 m.
I
After the entry of bobbin-thread winding length, press
J to return to the data input screen.
Press
L
O
<Bobbin check screen>
7)
Subsequently, place the second bobbin in the bobbin setting
K
section.
O in the similar manner.
8)
Press
9)
Now, the device starts winding bobbin. Wait a moment until
the device completes winding of bobbin.
K to return to the data input screen. Press
10) Press
M to display the sewing screen. Once the sewing screen is
displayed, sewing can be started.
– 28 –
L. Wait until the ini-
5)
Press
tialization operation of the device is
completed.
6)
Place the first bobbin in the bobbin
setting section. Then, press
O. The bobbin is taken in the
"3-3. How to set
device. (Refer to
a bobbin"
p.8 for the bobbin
setting procedure.)
B on the AW
I.
Advertisement
Table of Contents
