Table of Contents
Advertisement
Ⓒ : Empty bobbin loading button
This button is used for loading an empty bobbin in the hook ❶ .
Be sure to check that the bobbin to be loaded in the hook ❶ is empty before pressing
Ⓒ . If a threaded bobbin is loaded in the hook ❶ , a malfunction can occur when
winding the bobbin or removing the thread remaining on the bobbin.
Place an empty bobbin at bobbin case standby position ❷ and press
If no bobbin is present in hook ❶ , the empty bobbin placed as described above will be brought
•
to hook ❶ . Then, the device waits until the display is restored to the previous one and the next
bobbin is placed. The device starts winding a bobbin when
placing the next bobbin in the hook ❶ .
If a bobbin is already present in hook ❶ , the device will start winding of the bobbin.
•
Ⓐ : Bobbin change button
This button is used for winding a bobbin with new
❶
thread in the case of changing the thread, etc.
When
hook ❶ is replaced by another bobbin which is
present at bobbin case standby position ❷ . Then,
the thread remaining on the bobbin in hook ❶ is
removed and new thread is wound on the empty
bobbin.
Ⓑ : Bobbin take-out button
This button is used for taking out the bobbin load-
❷
ed in hook ❶ . Take out the bobbin that is pres-
ent at bobbin case standby position ❷ by hand
before pressing
pressed, the bobbin loaded in hook ❶ is brought
to bobbin case standby position ❷ .
– 18 –
Ⓐ is pressed, the bobbin fitted in
Ⓑ . Then, when
Ⓒ
.
Ⓓ is pressed after
Ⓒ
or
Ⓑ is
Advertisement
Table of Contents
