JUKI AW-3S Instruction Manual page 25

3-11-2. Bobbin-thread winding length
A
<Bobbin-thread winding length
setting screen>
3-11-3. Selecting the remaining-thread allowance length
A
<Remaining-thread allowance
length selection screen>
Ⓑ is pressed, the bobbin-thread winding length set-
When
ting screen is displayed.
A : Numeric keypad
Bobbin-thread winding length can be entered with the numeric
keypad.
Bobbin-thread winding length : Min. 2 m
Set the bobbin-thread winding length so that thread
wound on a bobbin do not protrude the bobbin case.
Refer to the table shown below for a guide for the bobbin-thread
winding length.
Nylon bond 6.6
Nylon bond 6.6
Nylon bond 6.6
Nylon bond 6.6
Ⓒ is pressed on the AW setting screen, the remain-
When
ing-thread allowance length selection screen is displayed.
On the remaining thread margin length selection screen, the re-
maining thread margin length can be set from 0 m to 3.5 m with
A.
The remaining-thread allowance length is used when the bobbin
change method is set to "auto".
– 23 –
Max. 200 m
TEX 135 TKT 020
TEX 105 TKT 030
TEX 70 TKT 040
TEX 45 TKT 060
Max. 12 m
Max. 22 m
Max. 30 m
Max. 45 m