Device Operation Lamp - JUKI AW-3S Instruction Manual

3-5. Device operation lamp

Lamp status
Light up (ON state)
Light off (OFF state)
1. In the case the power is turned OFF while the lamp is in the ON state intentionally or
unintentionally due to power failure or the like, it is necessary to remove the cover to
check whether or not the device is tangled with thread. (Refer to
the cover door"
2. If the device is tangled with thread, remove the thread and draw out thread from the
bobbin winder nozzle by approximately 13 cm. Then, attach the cover back. (Refer to
2. How to thread the device with the bobbin thread"
❶
Indicates that the device is in operation. While the lamp lights up, the device is en-
gaged in removal of remaining thread from the bobbin or winding of a bobbin. Do not
turn the power OFF unless there is an emergency.
Indicates that the device is in the standby state. Make sure that the lamp has gone out
before turning the power OFF.
p.5.)
Lamp ❶ mounted next to the power switch indi-
cates that the device is in operation.
Meaning
p.6.)
– 12 –
"3-1. Opening/closing
"3-