Regelsysteem - Gbs-Adres Instellen; Monteren Van De Deurschakelaar; Control System - Setting Bms Address; Door Contact Installation - flowair ELIS B W 100 Operation Manual

Table of Contents

Advertisement

5.3.8. REGELSYSTEEM - GBS-ADRES INSTELLEN

Wanneer DRV-modules op de T-box of een GBS worden
aangesloten, moet u de adressen binair instellen (elke
DRV-module moet een uniek adres hebben) op elke DRV-
module met behulp van DIP-switch SW1. Om de adressen
van modules te controleren zorgt u er eerst voor dat de
stroomvoorziening uitgeschakeld is. Stel vervolgens de
adressen in op de manier zoals is weergegeven in de tabel
en schakel dan de stroomvoorziening opnieuw in.
Adressen DRV
1
2
3
...
31
1
1
schakelaar omlaag
schakelaar omhoog

6. MONTEREN VAN DE DEURSCHAKELAAR

Voorbeeld voor het monteren van de deurschakelaar.
DCm - bij montage volgens het onderstaande aansluitschema
moeten de connectors 21 en 22 worden gebruikt.
Scharnierende deuren
Dce – bij schuifdeuren (waarbij de sensor en de magneet
evenwijdig worden gemonteerd) moet de afstand tussen de
sensorbehuizing en de magneet ten minste 9-12 mm zijn. Voor
scharnierende deuren mag de afstand tussen de
sensorbehuizing en de magneet niet groter zijn dan 8 mm.
Scharnierende deur
2
3
4
5
6
2
4
8
16
Y1
Schuifdeuren
5.3.8. CONTROL SYSTEM – SETTING BMS ADDRESS
When connecting DRV modules to the T-box controller or BMS,
you have to binary set addresses on each (each DRV must have
individual address) DRV module by DIP-switch SW1. To address
modules, check if the power supply is turned off, then set the
addresses as shown in the table, then turn on the power supply.
Addresses DRV
1
2
3
...
31
switch down
switch up

6. DOOR CONTACT INSTALLATION

Sample of door contact installation.
DCm – In case of installation in way which is show on drawing
below, connectors 21 and 22 need to be used.
Hinged doors
Dce – In the case of sliding doors (with a parallel installation of
the sensor and magnet ) is required distance 9-12 mm
between the sensor housing and the magnet. For Hinged door
max 8 mm between housing and magnet.
Hinged door
1
2
3
4
5
1
2
4
8
16
Sliding doors
www.flowair.com |21
6
Y1

Advertisement

Table of Contents
loading

Table of Contents