Table of Contents
Advertisement
General
This section covers the most common service adjustments
or procedures that may need to be made during the life
of your machine.
If you require additional machine service not included
in this section, please contact Woodstock International
Technical Support at (360) 734-3482 or send e-mail to:
tech-support@shopfox.biz.
Aligning Bending Wing
In order to achieve accurate bends, the top surface of
the bending leaf and the attached bending wing must be
flush with the top surface of the clamp block when the
bending leaf is in the down position (see Figure 29).
Check for proper alignment by examining how the edges
of each component meet each other. Only perform the
instructions below if the top surfaces of these compo-
nents are NOT flush with each other.
There are two adjustments that can be made to align
the clamp and bending wings. First, you can adjust the
ends of the bending leaf to make it even with the clamp
block; and second, you can straighten the main body of
the bending leaf or clamp block by tightening a large nut
on the center of a truss assembly, which is mounted to
each.
To align the clamp and bending wings, do these steps:
1. Loosen the bending leaf mounting bolts (Figure 30)
on each end of the brake.
SERVICE
Figure 29. Callouts showing where clamp
block and bending wing must be flush.
Figure 30. Bending leaf mounting bolts.
-24-
M1012 48" Pan and Box Brake
Advertisement
Table of Contents
