Table of Contents
Advertisement
General
This section covers the most common service adjustments
or procedures that may need to be made during the life
of your machine.
If you require additional machine service not included
in this section, please contact Woodstock International
Technical Support at (360) 734-3482 or send e-mail to:
techsupport@woodstockint.com.
Aligning.Bending.Block
To help ensure the bend is even along its length, the
bending block must be mounted flush with the top of the
bending leaf. The bending block is factory-aligned and
should only need re-alignment after extended use.
Tool.Needed.
Open-End Wrench 17mm.......................................1
To.align.bending.block,.do.these.steps:
1. Look closely along tops of bending block and bending
leaf (see Figure 19) to determine if they are out of
alignment.
2. Loosen (5) hex bolts (see Figure 19) that secure
bending block to bending leaf just enough to move it
up or down.
3.. Align bending block flush with top of bending leaf,
and then tighten hex bolts.
Model M1118 (For Machines Mfd. Since 09/21)
SERVICE
Qty
Bending Block
Figure.19. . Location of hex bolts for align-
-24-
Bending Leaf
Top of
Hex Bolt
(1 of 5)
ing bending block.
Top of
Advertisement
Table of Contents
