Table of Contents
Advertisement
M1012 48" Pan and Box Brake
Safety Instructions for Pan and Box Brakes
READ and understand this
entire instruction manual
before using this machine.
Serious personal injury
may occur if safety and
operational information is
not understood and fol-
lowed. DO NOT risk your
safety by not reading!
1.
OVERLOADING PAN AND BOX BRAKE. Overloading this tool can cause injury from flying parts. Bend
12 gauge or thinner metal.
2.
USING TORCHES. Heating metal with a torch while the metal is in the pan and box brake will weaken
the fingers.
3.
.
METAL EDGES
Always chamfer and de-burr sharp sheet metal edges
can cut your fingers to the bone. Always chamfer and de-burr sheet metal before bending in the pan
and box brake.
4.
GLOVES AND GLASSES. Always wear leather gloves and approved safety glasses when using this
tool.
5.
EXPERIENCING DIFFICULTIES. If at any time you are experiencing difficulties performing the intend-
ed operation, STOP using the tool and contact our Technical Support Department, or ask a qualified
expert how the operation should be performed.
6.
TOOLS IN POOR CONDITION. Inspect the pan and box brake for any cracked linkage, levers, or loose
fasteners. Correct any problems before use.
USE this and other machinery with caution
and respect. Always consider safety first,
as it applies to your individual working
conditions. No list of safety guidelines can
be complete—every shop environment is
different. Failure to follow guidelines could
result in serious personal injury, damage
to equipment or poor work results.
-7-
.
Sharp edges on sheet metal
Advertisement
Table of Contents
