ensto ECO10LCDJR Installation And Operation Instructions Manual page 5

Parameter
No Name Parameter description
01 SEnS Sensor selection
Calibrate internal sensor
Procedure: Before calibration, operate the thermo-
stat with same temperature setting for at least one
day. Put a thermometer at the same height as the
CAL
thermostat (approx. 1.5 m above the floor) and give
02
it enough time to stabilize. Press the joystick and
Air
enter the value that is read out from the thermom-
eter. Save by pressing the joystick.
Note! The heating element managed by the thermo-
stat must be in operation during the calibration.
Calibrate external sensor**.
Procedure: Before calibration, operate the ther-
mostat with same temperature setting for at least
one day. If the external sensor is used as floor
CAL
sensor, put the thermometer on the floor and give
03
it enough time to stabilize. Press the joystick and
SoL
enter the value that is read out from the thermom-
eter. Save by pressing the joystick.
Note! The heating element managed by the thermo-
stat must be in operation during the calibration.
Drying function for concrete floors.
When activated, this function starts a drying pro-
gram that lasts for 21 days. During the first 24 hours
1rst
the heating is on 2 hours totally. For each follow-
04
Heat ing day, another 1 hour of heating is added. The
temperature is limited to 20 ⁰C during the program.
The function is not stopped due to possible power
breaks.
Connected load [W].
05 LoAd
Do not connect a load that exceeds 2300 W to the
thermostat.
Exit the installation menu.
End
09
The program version is displayed.
Installer menu
RAK78 / © Ensto 2018
Alternative
Factory setting
Sens
Air Only Flor Only
Internal sensor External sensor
no
Not calibrated
Calibrated
no
Not calibrated Calibrated
no
Not activated
Activated
Adjustable 0 to
1500
2300 in steps of 50
Press the joystick.
E750 X.xx
setting
Sens
done
done
21
5