Media Types And Settings - Honeywell RP2 User Manual

Media Types and Settings

Media Type
Gap Label
Sensor Type
Gap
Setting
Continuous Label Length
(1/100 inch)
Label Width (1/100 inch)
Maximum Label Length
(1/100 inch)
Sensor Type
5. After updating the New Value column, ensure that the Include column
6. Allow 30 seconds for the printer to reset.
If you have issues with media registration after sending these settings to the
printer, refer to
RP2/RP4 User Guide
Notch Edge
Not Supported
checkbox is selected for the value, and click the Send button to send this
change to the printer.
Calibrate the Media
Notch Center
Gap
Description
Distance the printer will advance after pressing the Media Feed
button. Distance is measured in 1/100 inch, so 1000 = 10 inches.
200 = 2 inch media
300 = 3 inch media
400 = 4 inch media
Distance must be greater than the length of your media. Distance
is measured in 1/100 inch, so 1000 = 10 inches.
Gap = labels with gap
Continuous = media with no gap
Reflective = labels with Q-mark or black mark
on page 29.
Reflective
Continuous
(Black Mark)
Continuous
Black Mark (Top
Label Length
or Bottom)
(set value)
13