Connecting
3.1 FS200 Communications Setup
1. Connect the appropriate USB cable between the flowmeter and any available USB port
2. Turn on power to the flowmeter if it is not already powered up
3. Make sure to note what port number your PC assigns to this connection. If necessary,
4. Verify the communication configuration settings of the FS200 utility by accessing the
FS200 Programming Manual, 03/2020,
A5E02951525-AB
on the PC.
access the Control panel / System / Device manager of your PC to verify the port
assignment
Setup tab on the FS200 menu bar, then click communications (See Figure 3-1 Below).
Set as follows, then click OK;
Device address:
∂
Connect Using:
∂
Baud Rate:
∂
Stop Bits:
∂
Parity:
∂
Figure3-1 Communication settings
Typically 1
Select appropriate port as assigned by your PC
Select either 9600 or 19200
Typically 1
None
3
7