Advertisement
ML20700 PWI/PIP Series Mortise Lock
Frame Harness Installation
A
Supplied by CI
Crimp Connector
Ceiling
24AWG
Stranded
Drain
Wire for
Earth
Ground in
15' Frame
Harness
Frame-Side
Harness
Assembly
(15' length)
Cable drain wire
concealed in
shrink tubing
Hinge-side harness connectors:
• 4-pin male molex connector
• 6-pin male molex connector with ground wire
Lock-side harness connectors:
• Ring terminal
• (2) 4-pin connectors
Copyright © 2015 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the
express written permission of Corbin Russwin, Inc. is prohibited.
6) PIP (PoE) Installation Wiring (Continued)
Components and wire harness supplied by McKinney: Suggested installation.
Cut end / ceiling-side PoE harness:
B-Splice
RJ45-M
Do not confuse pair numbers with pin numbers. A pair number is
used for reference only (eg: 10BaseT Ethernet uses pairs 2 & 3). The
pin numbers indicate actual physical locations on the plug and jack.
Hinge side of PoE harness:
1. Feed cut end of harness into hole on hinge-side through single access
hole.
2. Push one of the connectors back through hole and feed into separate
access hole.
Each of the hinge-side harness connectors should end up threaded
through a different access hole and matched to the same size pin con-
nector from the door harness:
•
•
Molex-M
B
TIA/EIB-568-B Standard Wiring
Pair Number
1
2
3
4
4-pin male Molex connector.
6-pin male Molex connector with ground wire.
Notes:
•
Connectors only go on one way. They cannot be plugged to
incorrect position.
•
Do not force and do not offset connectors.
•
Be sure they are completely seated (flush).
4-pin M
B
6-pin M
Frame
21
Wire
White/Blue
White/Blue
Blue
White/Orange
White/Orange
Orange
White/Green
White/Green
Green
White/Brown
White/Brown
Brown
4-pin F
Drain Wire
6-pin F
PoE Hinge (Patent Pending)
PIN
5
4
1
2
3
6
7
8
Advertisement
