Vega POINTRAC 31 Operating Instructions Manual page 33

Menu language
Displayed value
Device status
Peak value indicator
Adjustment data
POINTRAC 31 • Foundation Fieldbus
6.3.2 Display
In the main menu point " Display", the individual submenu points
should be selected one after the other and provided with the correct
parameters to ensure the optimum adjustment of the display. The
procedure is described in the following.
This menu item enables the setting of the requested national lan-
guage.
In delivery status, the sensor is set to the ordered national language.
If no language is preset, you will be asked during setup.
With this parameter you can change the indication of the display.
You can choose if the display should show the actual pulse rate or the
electronics temperature.
6.3.3 Diagnostics
In this menu item, you can enquire the status of your sensor. In normal
operation, the sensor displays the message " OK". In case of fault,
you will find the corresponding fault code here.
The peak value function holds the max. and min. values during opera-
tion.
•
Pulse rates - min./max.
•
Temperature - min./max./actually
Here, you can retrieve the adjustment value of the sensor. This is the
percentage value of the max. pulse rate at which the sensor switches
over.
If you have carried out a single point adjustment, this is the entered
value. With a two-point adjustment, this is the calculated value.
The value is an indication for the reliability and non-repeadability of
the switching point.
6 Set up with the display and adjustment module
33