Vega POINTRAC 31 Operating Instructions Manual page 17

Sensor orientation
POINTRAC 31 • Foundation Fieldbus
Fig. 6: Mounting clamp
1 Screw M8 x 80
2 Hinge bolt clamp
3 Detector tube
4 Console
1. Determine the exact mounting position of the mounting clamp
and mark the holes.
Drill appropriate holes (max. M12) for fastening the mounting
clamps.
2. For mounting, insert the detector tube (3) into the V-shape holding
fixture of the console (4).
Draw the hinge bolt clamp (2) according to the illustration through
the console (4).
Screw the hinge bolt clamp (2) together and tighten the screw (1)
with a max. torque of 20 Nm (14.75 lbf/ft).
Note:
The mounting clamps do not come with fastening screws. Use fasten-
ing elements that are appropriate for the situation in your plant.
Level detection - max. detection
The POINTRAC 31 is suitable for level detection in liquids or bulk
solids. It is mounted at the height of the requested switching point.
4 Mounting
1
2
3
4
17