Dicom Print - GE VOLUSON 730Pro Basic User Manual

Select the destination desired and click the [Send] button.
To add a new destination, click the [Add] button, enter the information and click the [OK] button.
To confirm or modify the information concerning the destination, highlight the destination and click
the [Modify] button.
For further details review System Setup:
An image can be sent through 4 storage servers at the same time.
Test Connection:
First select the station to be tested using the right or left trackball key, then click the [Test] button. If
the TCP/IP connection to the remote station is active, the entry "Normal" will appear in the [Ping]
column. If the DICOM server on the remote station is active, the entry "Normal" will appear in the
[Verify] column.
This connection test may take up to 30 seconds.
After completing the procedure, click the [Send] button.
The selected exam is sent to the destination by the system.
15.3.10

DICOM Print

DICOM Selective Print
It is possible to print out image(s) selectively to a printer that is connected to the DICOM network.
Move the cursor to the individual image which to be printed. Then press the right trackball key [Set].
To select multiple images, hold down the [Ctrl] key on the alphanumeric keyboard and select each
image with the right trackball key [Set].
Click this icon. The number of selected images is displayed on the screen.
Click the [OK] button.
®
Voluson 730Expert - Basic User Manual
105850 Rev. 0
To specify a DICOM Address
Test the connection to a DICOM station (destination).
Sonoview
(chapter 17.3.8.1)
15-17