Volume Measurements - GE VOLUSON 730Pro Basic User Manual

13.4 Volume Measurements

There are four methods in which to measure the Volume of structures of different shapes.
1. To measure the volume of an ovoid using three distances (axis).
2. To measure the volume of the ovoid using one distance and ellipse.
3. To measure the volume of a globe using one distance (diameter).
4. To measure the volume in the 3D mode with the 3D MultiPlane method.
13.4.1 3 Distance Measurement
1. Select the [3 Distance] item.
2. Move the cursor to the start of the measurement by the trackball and press the right or left
trackball key. A second cursor appears.
3. Move the second cursor to the second point of the measurement by the trackball and press the
right or left trackball key.
To re-adjust the start point, press the upper trackball key [Change] before completing the
measurement. It alternates the control from one cursor to the other.
The distance of the two points is displayed and a new cursor appears.
4. Measure the second distance as above.
5. Press [Freeze] to return to the scan mode and scan the structure transverse to the first scan.
Press [Freeze] again. A new cursor appears.
Note: If you have scanned the second image in Dual mode previously, you can measure the third
distance within the second image.
6. Perform the measurement of the third distance in the same manner.
Remarks:
•
The Volume of the ovoid measured by three distances is displayed.
®
Voluson 730Pro - Operation Manual
105831 Rev. 0
•
3 Distance Measurement
•
1 Distance + Ellipse Measurement
•
1 Distance Measurement
•
1 Ellipse Measurement
•
3D MultiPlane Measurement
To measure volume using three distances.
Basic Measurements
(chapter 13.4.1)
(chapter 13.4.2)
(chapter 13.4.3)
(chapter 13.4.4)
(chapter 13.4.5)
13-7