Fuse Replacement - Integra Luxtec MLX Operation And Service Manual

M L X 3 0 0 w a t t X e n o n L i g h t s o u r c e

fUSE REPLACEMENT

to replace the fuse:
• The fuse for the light source is located in the power entry module in
the rear of the unit.
• Remove the hospital grade power cord from the back of the light
source.
• Using a small flat screwdriver, pry open the retaining
door (Figure 8)and pry out the red plastic block from the power
entry module (Figure 9).
• Check to see if the fuse is blown; if blown replace with a fuse of the
same rating (Luxtec P/n 600987, or t6.3aL250 ).
• Replace the red block in the housing.
• Snap the retaining door into place.
• Plug cord back into light source and retest the unit.
8
Figure 8
Figure 9