Table of Contents
Advertisement
3 . Use the plastic utensil to pres s the L-shaped bar. Th e plate n roller is released. You m ay
need to slight ly ope n the fron t c over to ejec t the platen roller.
Note :
Art is cut-away to s how detail.
4. Clean the pla ten rol ler and pr inthead us ing a c otton s wab moistened with is opropyl alc oho l.
5 . Allow time for th e parts to dry.
6 . Replac e the platen r oller.
7 . Snap the c over into plac e.
8 . Reload the la bels. See
C l e a n in g th e Di s p la y
Ma ke sure the pri nter is turned off whe n c leaning t he displa y. Use a s oft, l int-free c loth to
wipe the dis play.
Caution:
Do not us e s harp objec ts or abras ive c leaners on the dis play; they c an caus e
damage.
C l e a n in g th e Pr in te r
♦
Slightly dampen a c loth with water and wipe off th e printer's case.
♦
Open the c over and us e a dry, s oft-bristled brush to remove paper dust.
Caution:
Do not use hous ehold c leaners to c lean the printer.
5-2 Operator's Handbook
"Load ing Lab
els" in Chapter 1 for m ore inf ormation.
Advertisement
Table of Contents
