Maintenance And Cleaning; Cleaning The Printhead - Avery Dennison TTX 450 User Manual

TTX 450/650/950/1050 – Puma/Lion/Tiger/Tiger XXL – TDI/STDI/XXtreme –

Maintenance and cleaning

Clean printhead and feeding roller with cleaning liquor from paper, adhesive
and ink deposits at regular intervals.

Cleaning the printhead

• Disconnect unit
Attention: Pull off mains plug!.
•.Remove material and ribbon.
• Loosen hexagon socket screw at center of printhead axle by means of a
2mm allen key, until the printhead can be rotated clockwise.
Attention: The printhead is an electronic module and highly sensitive to static impacts. For
that reason discharge your static potential before going in contact with the
printhead by gripping the base plate of the printer. Do not remove plugs from the
printhead. If printhead is readjusted at axle mark ist position accordingly.
• Clean print roller with dust-free cloth and cleansing liquor only.
Attention: Never use knives or objects with sharp edges for cleaning. Metal objects must
never get in contact with the dot line.
• Put printhead to former position and fix screw again.
Note: The screw enters a non visible gap at the axle, which ensure the correct
position of the printhead. Factory adjustment is flash with the inner black
plastic bushing.
• Before switch on the unit, check that both connectors of printhead are still
plugged on correctly. Reconnect if necessary.
05/08
User Manual
S45/65/95/105
Rev. 2.14 26