Table of Contents
Advertisement
N. Temperature Conversion Status - Temperature related programs can be set in either Fahrenheit (ºF) or
Celsius (ºC). ALL temperatures will automatically convert to the corresponding values (+/- 1º) when changes
are made.
O. High-Temperature Protection - If the Phase 7 OPL microprocessor controller (computer) senses that the
temperature in the basket (tumbler) has exceeded 180º F (82º C) for axial airflow, 220º F (104º C) for radial
airflow and it will end the drying cycle and a fault code will be displayed, indicating an overheating problem.
P. Cycle Preview - Entire dryer parameters (programs) or the preprogrammed cycles are displayed for
verification upon a coded entry to the keyboard (touch pad).
Q. Reversing Option - Helps reduce the balling up or tangling of large items. A cycle can be set to have the
reversing option where the basket (tumbler) will turn in the forward direction from 30- to 120-seconds, stop
from 5- to 10-seconds, and then proceed in the reverse direction for the same time. This process is repeated
throughout the drying and cooling cycles.
R. RPM - Phase 7 microprocessor controller (computer) also displays basket (tumbler) RPM by pressing and
holding the "DOWN ARROW" key and holding it while the basket (tumbler) is on. (The basket [tumbler]
must be rotating for approximately 30-seconds before getting a true RPM reading).
S. Clean Lint - This feature monitors the value of the "Lint Count" register. The register contains the acceptable
limit of dryer cycles the machine will be allowed to operate before the microprocessor locks the user out.
Once the feature prompts the user to "CLEAN LINT ACCESS" the dryer is now in a locked state and will
not be cleared until the lint drawer has been cleaned. When the lint drawer is opened, the display will read
"LINT ACCESS OPEN" and when the lint drawer is closed, the display will read "READY." (NOTE: The
lint drawer must be opened for 15-seconds or more for the reset to occur.) The dryer circuit is now active
and can be programmed.
T. Language Selection - Phase 7 has the ability to display 5 different languages, English, French, Spanish,
Italian, and German.
U. Model Selection - The Phase 7 can be programmed to be used on 3 modes of heat, gas, steam and electric.
It can also be configured for reversing and non-reversing dryers.
V. Default Factory Settings - This feature will set ALL programmed parameters to their default values.
W. Keyboard (Touch Pad) Symbols -
X. Steam Injection Option - The Phase 7 has the ability to program up to 5 steam injection intervals for a
programmed amount of time at different points of a cycle including cool down.
= "STOP/CLEAR" key
= "START/ENTER" key
= "UP ARROW" key (scroll up)
= "DOWN ARROW" key (scroll down)
5
Advertisement
Table of Contents
