Manually Loaded Cycles - Maytag PHASE 7.2 User Manual

c. Dryness Level - Programmable for finishing, dry, and extra dry.
d. Cool Down Time - Programmable from 0 to 99 minutes in 1 minute increments.
e. Cool Down Temperature - Programmable from 70º F to 100º F (21º C to 38º C) in one-degree increments.
f. Cycle Adjustment - Programmable from 0 to 99.
2. Timed (Manual) Cycle
a. The Phase 7 OPL microprocessor controller (computer) can be programmed to reverse or not reverse.
This is done in "DRYER SETUP" parameter.
b. Drying Time - Programmable from 0 to 99 minutes in 1 minute increments.
c. Drying Temperature - Programmable from 100º F to 200º F (38º C to 93º C) in one-degree increments.
d. Cool Down Time - Programmable from 0 to 99 minutes in 1 minute increments.
e. Cool Down Temperature - Programmable from 70º F to 100º F (21º C to 38º C) in one-degree increments.
f. The Spin Time can be programmed from 30-seconds to 120-seconds in 1-second increments.
g. The Dwell (stop) Time can be programmed from 5-seconds to 10-seconds in 1-second increments.
h. Steam Injection (optional) - Programmable 0-5 intervals.
ALL six (6) "A-F" preprogrammed cycles along with cycles "0-40" have been programmed by the
factory as outlined in Section VII. However, even though cycles "A-F" are the most common cycles
used, they should be reviewed to ensure they meet the location application or needs. Should changes
be found necessary, refer to the Programming Section of this manual.
B. MANUALLY LOADED CYCLES
For occasional or onetime special loads, the operator must enter the specific program features needed. This
cycle is not stored within the Phase 7 OPL microprocessor controller (computer) and must be entered each and
every time.
The Manually Loaded Cycle can be set in either the Automatic Drying Mode (Patent No. 4,827,627) or the
Timed (manual) Drying Mode. These are selected by pressing the "AUTO" or "MAN" keys on the keyboard
(touch pad).
7