Display Messages; Display Operating Status - Maytag PHASE 7.2 User Manual

The light emitting diode (L.E.D.) display informs the operator of cycle status, program verification, and displays
important diagnostic messages and fault information.
A. L.E.D. DISPLAY OPERATING STATUS
1. Cycles in Progress
a. While the dryer is operating, the L.E.D. display will read which cycle is in progress. I.E., in a Manual
Drying Cycle (mode), the L.E.D. display will read "MANUAL DRYING CYCLE." In the Cool Down
Cycle (mode) the L.E.D. display will read "COOL DOWN TEMP __, __ MINUTES REMAIN."
2. Cycle Status
a. While a cycle is in progress, the L.E.D. display will show the progress of the cycle that is being
processed.
1) Automatic Drying Cycle
a) While a cycle is in progress the cycle status will display ELAPSED TIME __ MIN. During the
Drying Cycle, the Phase 7 OPL microprocessor controller (computer) is monitoring the moisture
in the load. Once the temperature has reached set point temperature and cycled ON/OFF for
three (3) times, the cycle status portion of the L.E.D. will change from ELAPSED TIME __
MIN to __% DRY. The display will count upward until the percentage of extraction programmed
is reached.
2) Timed (Manual) Drying Cycle
a) While a cycle is in progress the cycle status will display __ MINUTES REMAIN.
3. Alternate Display Programs
a. The basket's (tumbler's) RPM can be displayed by pressing and holding the "DOWN ARROW" key
while a cycle is in progress. If a cycle is not in progress, the board voltage is displayed.
b. The basket (tumbler) temperature can be displayed by pressing and holding the "UP ARROW" key at
any time.
SECTION V
L.E.D. DISPLAY MESSAGES
19