Maytag PHASE 7.2 User Manual page 18

5) Once the preprogrammed percentage of extraction (dryness level) is reached, the drying cycle will
end and the Cool Down Cycle will begin.
6) Once the Cool Down Cycle begins at the end of the heat cycle, the light emitting diode (L.E.D.)
display will read COOL DOWN TEMP ___/___ MINUTES REMAINING. At the end of the
heat cycle, the dryer will shut off the heat and continue the fan and basket (tumbler) until the Cool
Down Time or temperature is reached.
7) Once the Cool Down Cycle is completed the Phase 7 OPL microprocessor controller (computer)
will proceed into the Wrinkle Guard Cycle. The Audio Alert tone will sound (for amount set in
Audio Alert On Time). The L.E.D. display will read "WRINKLE GUARD." The times are fixed
at 2 minutes OFF, 2 minutes ON for a maximum time of 99 minutes. These times are not
programmable. During the ON time, the blower (fan) and the basket (tumbler) will start to rotate
(without heat for 2 minutes). The Phase 7 OPL microprocessor controller (computer) will repeat
this process until the Maximum Wrinkle Guard On Time has expired (99 minutes). The L.E.D.
display will then read "CYCLE DONE" and lockout the dryer functions until the doors are opened.
It will then return to "READY."
b. Timed (Manual) Drying Cycle
1) L.E.D. display reads "READY" (no cycle in progress).
2) Press the letter on the keyboard (touch pad) corresponding to the cycle desired (i.e., key "D").
NOTE: "0-40" WILL REQUIRE THE "START/ENTER"
NUMBER IS SELECTED IN ORDER TO ACCEPT THE SELECTION and START
DRYING.
3) The dryer will then start. (I.E., blower, basket [tumbler], and heat).
4) The L.E.D. display will read MANUAL DRYING CYCLE D, 00:00 MIN REMAIN.
NOTE: Press and hold the "UP ARROW" to view the basket (tumbler) temperature at any time.
NOTE: The dryer can be stopped at any time by pressing the "STOP/CLEAR"
dryer will go into a cycle pause. If the "STOP/CLEAR"
the cycle that was in progress will be cancelled and returned to the "READY" state.
NOTE: Press and hold the "DOWN ARROW" to view the basket (tumbler) RPM.
5) When the programmed drying time has expired, the Phase 7 OPL microprocessor controller
(computer) will proceed into the Cool Down Cycle.
6) Once the Cool Down Cycle begins at the end of the heat cycle, the L.E.D. display will read COOL
DOWN TEMP ___/___ MINUTES REMAINING. At the end of the heat cycle, the dryer will
shut off the heat and continue the fan and basket (tumbler) until the Cool Down Time or temperature
is reached.
KEY TO BE PRESSED AFTER THE
l
key is pressed again at this point,
O
14
key, at this time the
O