Table of Contents
Advertisement
installation dimensions
depth: minimum 24" needed for proper installation
overall
Valve (front view)
height
79"
height
to center
incomng
68-3/4"
tank
height
height
to center
65"
outgoing
68-3/4"
height
to center
drain
73"
weight dry: approx 350 lbs
weight wet: approx 850 lbs
Due to variations in installations, length and sizing needed for pipe connections to and from the system (see flexible requirement) and drain line are not supplied
Flexible Connections Required:
Stainless steel corrugated water connectors, PEX or PVC Sch 40 have a flexible capability that may assist with issues where the
rough and finish measurements are slightly off or where pressure surges/spikes or back pressure occur. This flexible connection may
prevent tank and valve issues where rigid or hard pipe create problems over time. This is a requirement of the tank manufacturer
and is stated on the label affixed to every tank. Perform all plumbing according to state or local codes.
Drain Line Air Gap Required and Spring Check Highly Recommended:
Please see information for proper drain line installation in the Product and Installation guide
Complete setup, install and startup of these systems can be found in this Product and Installation Guide
CauTIoN: If installing other equipment in addition to this system - Contact customer service for proper order of installation
- Model #'s eWs-1665-2, CWl-1665-2, eWs-CC-2472-2, CWl-CC-2472-2
For Illustration Purposes Only:
On-Site Assembly Required
due to shipping weight for all larger systems,
tank, all tank contents and valve must be assembled on site.
Please review the simple steps for proper assembly.
Pictured:
eWs-1665-2, CWl-1665-2
This is an example of 3 valve
bypass using corrugated flexible
2.0" brass close or shoulder
nipples, 2.0" corrugated flex-
ible stainless, all incoming/
outgoing piping and 3 ball
valves are not supplied
self leveling
base
tank width 16"
overall
height
88"
For Illustration
Purposes Only:
stainless to make the final
connections with the valve.
Configuration may vary
Plumber installed
bypass is required
CAUTION:
all measurements are
approximates and system
heights may have
variances up to 2".
*Not Supplied:
Pictured:
eWs-CC-2472-2, CWl-CC-2472-2
depth: minimum 28" needed for proper installation
Valve (front view)
height
to center
incomng
tank
78"
height
72"
height
to center
outgoing
78"
height
to center
drain
82-1/4"
weight dry: approx 650 lbs
weight wet: approx 2,400 lbs
4
tank width 24"
For Illustration Purposes only:
Corrugated flexible stainless not supplied
Advertisement
Table of Contents
