Table of Contents
Advertisement
go through home/facility checklist and check your work
17.
System is ready for use.
Turn on gas or electric supply to the water heater(s).
To ready facility for filtered water, please flush all the water throughout the home.
open as many hot and cold faucets through out the home as possible,
remove the aerators or any restriction at the end of the faucets,
run tubs (if applicable),
flush toilets,
dispose of any ice previously made
run water throughout facility home for 5 minutes.
18.
Final Checklist
check all connections,
pressure not to exceed 75 psi,
make sure system was not installed backwards
using the proper flexible piping
make sure drain is correctly installed and drain water was running clear.
NoTe: Cloudy WaTer
If water appears cloudy, allow to run for several more minutes until all air is expelled or until clear.
NoTe: Pre-exIsTINg CoNdITIoNs, older HoMes or FaCIlITIes, HeaVy sedIMeNT
If location is a year or more old, it is highly recommended that all water heaters or tankless on-
demand heaters be flushed and that all dishwashers, washers and any other water appliances be
cleaned of any existing residue.
Please review Page 6 "Instructions before using" for existing plumbing and pre-existing
conditions that will effect the performance of this system.
WARNING:
Failure to follow these procedures can result in debris in the system, the system's valve, the home
or facility, and/or filtration media being expelled. Expelled media will cause immediate short and
long term issues with the system's valve, and will enter pipes and the fixtures or appliances within
the home or facility.
16
Advertisement
Table of Contents
