Last Steps Before Leaving The System - Environmental Water Systems EWS-1665-2 Product And Installation Manual

check the drain water and put system in service
15. Observe the drain water during Cycle 3. Rapid Rinse
If the water is running clear - proceed to Step #16.
If the water remains grey - go back to Step #13 on Page 14.
CAUTION:
Extra
Cycle
button
16. Open outlet and put the system in final service position
If the drain water remains grey,
Press the Extra Cycle Button
and repeat the flushing sequence
until the water from the drain line runs clear.
valve
open
in raw
water supply
This is the service Position
inlet open
outlet open
bypass between the inlet and outlet is closed
(see illustration below)
outlet
inlet
from valve
to valve
valve
open
bypass
closed
out filtered to
home or facility
from water supply to system
from system to home
CYCLE 3 00:09:59
RAPID RINSE
minimum
1" air gap
15
look for clear
water coming
from the drain