Labconco RapidVap 73200 Series User Manual page 21

Chapter 4: Using Your RapidVap Vertex Evaporator
Pre-Heat:
If it is necessary to pre-heat the chamber before starting a run, press Pre-Heat.
This display will show:
BLOCK
Stop
Press "Stop" to return to the opening display and turn off the heater or press
"SET TEMP" to set the pre-heat temperature. The display will show:
BLOCK
Stop
The "SET TEMP" will flash. Then press "Up" or "Down" to adjust the block
temperature. In this example 52 is the temperature of the sample block, 51 is
the upper block or sample temperature. The heater will heat the block and
maintain it at the set temperature. Press "Stop" to turn the heater off and to
return to the opening display.
Product Service 1-800-522-7658
SAMP
52 51
SAMP
52 51
Up
SET
TEMP
85
SET
TEMP
90
Down
17