Labconco RapidVap 73200 Series User Manual page 20

Chapter 4: Using Your RapidVap Vertex Evaporator
Program:
To enter a new program while in the opening display press "PROG" and the
display will show:
PROG
Back
Press "Back" to return to the opening display, press "Run" to start this
program. If the program, temperature or time needs to be changed, press
either "PROG," "TEMP" or "TIME." The display will show:
PROG
Back
Ten different programs may be stored and then later recalled. Press "PROG"
or "TEMP" or "TIME" and the word will start to flash. Press "Up" or
"Down" to change the value. Another word may be selected and the value
under the word may be changed by pressing "Up" or "Down." Press either
"Run" to begin the run or press "Back" to return to the opening display.
If "TIME" is set to ON, the program will run continually until turned off by
pressing "STOP" or "PAUSE."
16
TEMP
1 35
TEMP
3 67
Up Down
Product Service 1-800-522-7658
TIME
62
Run
TIME
74
Run