Cutting Procedures; Maintenance; Safety Instructions - Raider RD-CS21O Manual

14 www.raider.bg
•Use extra caution when sawing into existing walls or other blind areas. The protruding blade may cut objects that can cause
kickback.

CUTTING PROCEDURES:

• Danger: Keep hands away from cutting area and the blade. Keep your second hand on auxiliary handle, or motor housing.
If both hands are holding the saw, they cannot be cut by the blade.
• Do not reach underneath the work piece. The guard cannot protect you from the blade below the work piece.
• Adjust the cutting depth to the thickness of the work piece. Less than a fool tooth of the blade teeth should be visible below
the work piece.
• Never hold piece being cut in your hands or across your leg. Secure the work piece to a stable platform. It is important to
support the work properly to minimize body exposure, blade binding, or loss of control.
• Hold power tool by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden
wiring or its own cord. Contact with a "live" and shock the operator.
• When ripping always use a rip fence or straight edge guide. This improves the accuracy of cut and reduces the chance of
blade binding.
• Always use blades with correct size and shape(diamond versus round) of arbor holes. Blades that do not match the mounting
hardware of the saw will run eccentrically, causing loss of control.
• Never use damaged or incorrect blade washers or bolt. The blade washers and bolt were specially designed for your saw,
for optimum performance and safety of operation.

MAINTENANCE

1. Unplug the power cord before cleaning the saw.
2. Clean the machine regularly, so ensure its longevity.
3. Lubricate with oil periodically rotating circular elements.
4. Periodically check the wear of carbon brushes for electric motors. Allowable wear should not be more than 5-6 cm
5. When replacing the carbon brushes let the machine run for 10 minutes at idle. To change it is necessary to develop a
screwdriver caps on both sides of the hull.
6. Periodically inspect the power cord injuries. Upon finding such as contact company service out of warranty.

SAFETY INSTRUCTIONS

Use of electrical saw is the tool in order
reduce the risk of fire, electric shock and injury, they must be subject to the following basic safety
precautions.
Read all these instructions BEFORE to launch this product. Keep these instructions:
1. Check the rating of, with companies indicated on the plate.
2. Keep the tool do the work area clean.
Clutter operate the site increases the risk of accidents;
3. Be aware to operate the site conditions
Do not leave the tool to rain. Do not use the tool in damp or wet environment. Work saw is good lighting. Do not use the tool near
flammable liquids or gases;
4. Protective hair against electric shock
Avoid contact with the body grounded surfaces (eg pipes, radiators, ovens, refrigerators);
5. Do not allow children away
Do not allow outsiders to contact tool or cord; Hold them off operate the place.
6. Keep unused tool in place
Keep the tool when not in use at the moment, locked in a dry, which can be accessed by children;
7. Do not overload the tool