Before Use - Raider RD-CS21O Manual

WARNING
Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in
electric shock, fire and/or serious injury. Save all warnings and Instructions for future reference.
Used symbols on marking plate of the machine:
Refer to instruction manual/
booklet
Wear hearing protection
Wear eye protection
CIRCULAR SAW SAFETY WARNINGS.
Usage. This machine is suitable for cutting wood, other similar materials and plastic.
BLADE CHANGING PROCEDURE:
Pull the plug out of the socket before making adjustments or servicing. Press the lockout button on the
rotor and hold it down. Slowly rotate the disc with the key until the lock is triggered. Unscrew the disc fixing
screw by turning left. Pull the fuse with the lever and remove the disc. The contact areas between the inner
flange, disc, outer flange and fixing screw must be dust-free. Insert a new disc, making sure the direction
of rotation is correct. The direction of rotation is indicated by the arrow on the disc and on the fuse. Tighten
the fixing screw.
Do not use abrasive discs. Use only sharp, undamaged discs. Do not use cracked or discolored discs. Do
not use discs made of highly alloyed high-speed steel. Do not use discs that do not meet these guidelines.
The disc must be suitable for idle speed. Use a cutting disc suitable for the workpiece.

BEFORE USE

Attention! Before you start working with circular saw, check the voltage and frequency of the
electrical network.
Attention! Check whether the protective cover is moving normally, without interfering in some sort
of way blade.
Attention! Place the blade by selecting disk rendered technical parameters.
1. Check the blade meets the following requirements: its speed is equal to or greater than that of the
circular.
Attention! Never use cracked or damaged saw blade.
2. Before placing the blade make sure saw is disconnected from the power cord. And the key is in position
Wear dust mask
Double insulated for additional
protection
11