Clutch - Husqvarna K1270 II Workshop Manual

8. Tighten the screws around the crankshaft in correct
order, refer to the illustration, torque 10–11 lbf·ft/14–
15 Nm. Make sure that the crankshaft moves freely
after it is assembled. Hit the ends of the shaft with a
small plastic hammer to release tension.
2-8
4-10
5-11 1-7
9. Cut the gasket at the cylinder face.
Examine the crankcase for leakages after the cylinder is
assembled.
54 - Repair and servicing
6-12
3-9

6.13 Clutch

6.13.1 To remove the clutch
To remove the clutch, use a Husqvarna piston stop,
Servicing tools overview on page 11 .
refer to
1. Lock the crankshaft with the piston stop.
2. Release the clutch clockwise.
CAUTION: Do not hit the puller, the piston
can break. Do not use a hammer or
equivalent without the piston stop. It can
cause damage to the lock mechanism of the
flywheel slot.
1273 - 001 - 04.11.2019