Note: Do not use the piston stop on this product.
1. Put the support plate below the piston.
2. Seal with a cloth or paper to make sure that parts do
not fall into the crankcase.
3. Remove the snap rings on the 2 sides of the wrist
pin.
1273 - 001 - 04.11.2019
4. Push out the wrist pin by hand. If it is tight, use a
small hammer and light force.
5. Remove the piston.
6. Push the needle bearing out of the connecting rod.
7. Remove the piston rings.
6.8.4 To examine cylinder wear
Examine the cylinder bore against the light. You can
continue to use the cylinder if the surface layer has not
Repair and servicing - 43