Throttle Trigger And Throttle Lock - Husqvarna K1270 II Workshop Manual

3. Open the hose clip with a screwdriver.
4. Discard the hose clip.
6.15.3 To assemble the wet system
1. Put the spray nozzles on to the blade guard.
2. To put the filter in the connector, push it in on a flat
surface.
62 - Repair and servicing
3. Install new hose clips and close the hose clips with a
pair of pliers.

6.16 Throttle trigger and throttle lock

6.16.1 To remove the throttle trigger and throttle
lock
When you remove the throttle lock, use a V-jaw
adjustable pliers. Make sure that you hold the V-jaw of
the pliers adjacent to the handle. Put a cloth on the
throttle lock before you apply the pliers to prevent
damage to the surface.
1273 - 001 - 04.11.2019