Lubricating the guide rollers
•
Connect the grease gun to the grease nipples.
•
Pump in grease until clean grease emerges from the
overflow hole.
Adjusting the drive belt
The drive belt is fully enclosed and well-protected from dust,
dirt and mechanical damage when cutting.
•
Dismantle the cover and loosen the belt tensioning screw.
•
Press on the belt tensioner with your thumb to tension the
belt. Now tighten the screw holding the belt tensioner.
MAINTENANCE
Belt tensioning/replacing the drive
belt
•
Dismantle the cover and loosen the belt tensioning screw.
Push back the belt tensioning roller and install a new drive
belt.
CAUTION! Make sure that both belt pulleys are clean and
undamaged before a new drive belt is fitted.
•
Press on the belt tensioner with your thumb to tension the
belt. Now tighten the screw holding the belt tensioner.
•
Fit the belt cover.
!
Belt pulley and clutch
Never start the engine when the belt pulley and clutch are
removed for maintenance.
WARNING! Never use the power cutter
without a blade guard over the cutting blade.
– 19
English