To Assemble The Cylinder; Crankcase - Husqvarna K1270 II Workshop Manual

6.11 To assemble the cylinder

1. Clean and remove remaining bits of the first gasket
from the surfaces that connect with the gasket.
2. Put the gasket on the cylinder.
3. Make sure that the opening on the piston rings
aligns with the guide pin.
4. Push the piston rings together, use the piston ring
compressor.
1273 - 001 - 04.11.2019
5. Push down the cylinder on the piston and let the
piston ring compressor move along the piston.
Tighten the screws crosswise to a torque of 10–11
lbf·ft/14–15 Nm.

6.12 Crankcase

6.12.1 To examine the crankcase for leaks
A crankcase with a leak has lower crankcase
compression. A typical sign is that the product cannot
easily start.
There are special tools to seal the exhaust and inlet
ports of the cylinder. Refer to
Servicing tools overview
Repair and servicing - 47