Husqvarna K1270 II Workshop Manual page 60

4. Remove the bearings from the blade shaft with a
universal puller.
6.14.3 To assemble the blade shaft bearing
CAUTION: Do not put force between the inner
and outer rings of the blade shaft bearing. The
bearings can become damaged.
Use a hydraulic press or a Husqvarnabearing press kit
to assemble the blade shaft bearings. Refer to
tools overview on page 10 .
• If you replace the blade shaft bearings with a
hydraulic press, use the Husqvarna hydraulic
bearing press, refer to
page 10 .
• If you replace the blade shaft bearings with a
bearing press kit, use the Husqvarna bearing press
Servicing tools overview on page 10 .
kit, refer to
1. To assemble the blade shaft bearing with a hydraulic
press:
a) Put a piece of wood below the area for the blade
shaft bearing to put the bearing housing in level
position.
60 - Repair and servicing
Servicing
Servicing tools overview on
b) Put the blade shaft bearing on the bearing
housing and put the hydraulic press on top of the
blade shaft bearing.
c) Push down the blade shaft bearing fully to the
stop in the bearing housing.
2. To assemble the blade shaft bearing with a bearing
press kit:
a) Put the bearing and the bearing press.
b) Pull in the bearing to the stop
1273 - 001 - 04.11.2019